Notifications
Clear all
Chris P
Chris P
Skupina: Registrovaný
Přidal se: 2020/05/12
Eminent Member
2
@pcweber Thanks Phil!

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
Just changed nozzle and noticed this....

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
@neophyl Thank you so much for explaining this to me. I was ...

In forum How do I print this? (Printing help)

před 4 years
@neophyl Unless I'm doing it wrong, this particular fan duct...

In forum How do I print this? (Printing help)

před 4 years
Thank you all for the responses!!

In forum How do I print this? (Printing help)

před 4 years
Another question, I'm assuming that to replace the fan duct ...

In forum How do I print this? (Printing help)

před 4 years
Thank you both for your responses. I have the Prusa orange P...

In forum How do I print this? (Printing help)

před 4 years
Also, why ABS and not ASA? I thought ASA was better and less...

In forum How do I print this? (Printing help)

před 4 years
Material choice for updated fan duct on MK3S

In forum How do I print this? (Printing help)

před 4 years
@mark1 Thanks for clarifying. I'm going to try it.

In forum How do I print this? (Printing help)

před 4 years
@mark1 Thanks. Is one better than the other?

In forum How do I print this? (Printing help)

před 4 years
@pcweber Thanks for all the great info. When I get home I'm ...

In forum How do I print this? (Printing help)

před 4 years
@nikolai-r I am not printing in an enclosure but I think the...

In forum How do I print this? (Printing help)

před 4 years
@pcweber That looks really good. I will check my nozzle agai...

In forum How do I print this? (Printing help)

před 4 years
@pcweber I did check the nozzle and it appears to be fine. I...

In forum How do I print this? (Printing help)

před 4 years
Thanks for the replies and help. I will adjust those setting...

In forum How do I print this? (Printing help)

před 4 years
Well I printed another model with the new settings and it di...

In forum How do I print this? (Printing help)

před 4 years
I'm printing it now with 3 perimeters and 10% infill. I'll l...

In forum How do I print this? (Printing help)

před 4 years
@neophyl Thanks for the reply. I found the perimeter value s...

In forum How do I print this? (Printing help)

před 4 years
Just printed at 205 ֯C and still has hull issue circumferent...

In forum How do I print this? (Printing help)

před 4 years
Stránka 1 / 2
Share: