Carl A – Activité – Prusa3D Forum

Notifications

Clear all

Carl A

Groupe: Enregistré

A(ont) rejoint: 2017/06/12

Estimable Member

	I have a complete enclosure for my all my printing but close... Dans le forum General software discussion	il y a 5 years
	Yes, sorry about the wrong terminology. I thought it might b... Dans le forum General software discussion	il y a 5 years
	Bed fan speed when printing ABS Dans le forum General software discussion	il y a 5 years
	I measured the ohms and it read 3.6 so no problem with the h... Dans le forum General discussion, announcements and releases	il y a 5 years
	I appreciate the information and will check my printer out f... Dans le forum Hardware, firmware and software help	il y a 5 years
	Couple of things: 1. the sock worked. I did install an E3D p... Dans le forum General discussion, announcements and releases	il y a 5 years
	Update: Reflashed the latest FW. Decided to try to do a paus... Dans le forum General discussion, announcements and releases	il y a 5 years
	Update: size of print (LxW) does not matter. First layer pri... Dans le forum General discussion, announcements and releases	il y a 6 years
	Let me add that I just sliced the same file and am printing ... Dans le forum General discussion, announcements and releases	il y a 6 years
	Thurmal Runaway strange behavior Dans le forum General discussion, announcements and releases	il y a 6 years
	@margaret-m I have the file that I developed for both the PR... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	I ordered 200 sheets of 7 mil 8.5x11" from CFS Binding Suppl... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	I am using a Silhouette Cameo (similar to a Circut) to cut t... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	No problem: I did order some .03" (1/32" thick clear 12" x 1... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	I found some 3/4" 10 yard (2 each - 5 yard black/white) butt... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	Bed temp failure error - Thermal Runaway Bed and Mintemp bed Dans le forum Hardware, firmware and software help	il y a 6 years
	I have these on order and should see them by the first of th... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	@thedachtlers I received from Amazon and found that these ar... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	I ordered this from Amazon. Thanks for the heads up. Hope th... Dans le forum Coronavirus (COVID-19)	il y a 6 years
	I have a Silouette (same as Circuit) but cannot find the pla... Dans le forum Coronavirus (COVID-19)	il y a 6 years

Page 4 / 7 Précédent Suivant

Statistiques du forum

595 Forums

69.9 K Sujets

489.3 K Messages

15 En-ligne

80.6 K Membres

Le dernier des messages: Fine horizontal lines on exterior when an internal feature ends, how do you get rid of this? Notre nouveau membre: SciPrint Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé