Carl A – Aktivita – Prusa3D Forum

Notifications

Clear all

Carl A

Skupina: Registrovaný

Přidal se: 2017/06/12

Estimable Member

	I have a complete enclosure for my all my printing but close... In forum General software discussion	před 5 years
	Yes, sorry about the wrong terminology. I thought it might b... In forum General software discussion	před 5 years
	Bed fan speed when printing ABS In forum General software discussion	před 5 years
	I measured the ohms and it read 3.6 so no problem with the h... In forum General discussion, announcements and releases	před 5 years
	I appreciate the information and will check my printer out f... In forum Hardware, firmware and software help	před 5 years
	Couple of things: 1. the sock worked. I did install an E3D p... In forum General discussion, announcements and releases	před 5 years
	Update: Reflashed the latest FW. Decided to try to do a paus... In forum General discussion, announcements and releases	před 5 years
	Update: size of print (LxW) does not matter. First layer pri... In forum General discussion, announcements and releases	před 6 years
	Let me add that I just sliced the same file and am printing ... In forum General discussion, announcements and releases	před 6 years
	Thurmal Runaway strange behavior In forum General discussion, announcements and releases	před 6 years
	@margaret-m I have the file that I developed for both the PR... In forum Coronavirus (COVID-19)	před 6 years
	I ordered 200 sheets of 7 mil 8.5x11" from CFS Binding Suppl... In forum Coronavirus (COVID-19)	před 6 years
	I am using a Silhouette Cameo (similar to a Circut) to cut t... In forum Coronavirus (COVID-19)	před 6 years
	No problem: I did order some .03" (1/32" thick clear 12" x 1... In forum Coronavirus (COVID-19)	před 6 years
	I found some 3/4" 10 yard (2 each - 5 yard black/white) butt... In forum Coronavirus (COVID-19)	před 6 years
	Bed temp failure error - Thermal Runaway Bed and Mintemp bed In forum Hardware, firmware and software help	před 6 years
	I have these on order and should see them by the first of th... In forum Coronavirus (COVID-19)	před 6 years
	@thedachtlers I received from Amazon and found that these ar... In forum Coronavirus (COVID-19)	před 6 years
	I ordered this from Amazon. Thanks for the heads up. Hope th... In forum Coronavirus (COVID-19)	před 6 years
	I have a Silouette (same as Circuit) but cannot find the pla... In forum Coronavirus (COVID-19)	před 6 years

Stránka 4 / 7 Předchozí Další

Fórum Statistiky

595 Fóra

69.9 K Témata

489.2 K Příspěvky

15 Online

80.6 K Uživatelé

Poslední Příspěvek: Solidworks xDesign Nový Uživatel: SciPrint Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed