Prusa3D Forum

Notifications

Clear all

CAR

Grupa: Zarejestrowany

Dołączył: 2019/03/20

Active Member

	Thanks @Jürgen, I did actually use that info screen. It appe... In forum Hardware, firmware and software help	1 week temu
	I just checked the unit, and both the upper and lower filame... In forum Hardware, firmware and software help	1 week temu
	@chmax - Thank you for the hint. I'm heading there right now... In forum Hardware, firmware and software help	1 week temu
	Filament runout - faulty filament sensors? or proper behavio... In forum Hardware, firmware and software help	1 week temu
	@eliarchercohen Thank you. I think this should get me start... In forum Coronavirus (COVID-19)	6 years temu
	Help with Stacks of RC3 face shields In forum Coronavirus (COVID-19)	6 years temu
	@bobstro - you were 100% correct about the speed/flow rate. ... In forum How do I print this? (Printing help)	7 years temu
	Fantastic, thank you for the reply. I will absolutely try t... In forum How do I print this? (Printing help)	7 years temu
	Bad surface on larger (>75mm Diameter) prints, while smal... In forum How do I print this? (Printing help)	7 years temu
	[Build Problems] E-Exis FS-Cover Assembly Issue In forum Assembly and first prints troubleshooting	7 years temu

Statystyki Forum

595 Fora

68.9 K Tematy

481.7 K Posty

13 Online

77.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte