Prusa3D Forum

Benachrichtigungen

Alles löschen

CAR

Gruppe: Registriert

Beigetreten: 2019/03/20

Active Member

	Thanks @Jürgen, I did actually use that info screen. It appe... Im Forum Hardware, firmware and software help	Vor 1 week
	I just checked the unit, and both the upper and lower filame... Im Forum Hardware, firmware and software help	Vor 1 week
	@chmax - Thank you for the hint. I'm heading there right now... Im Forum Hardware, firmware and software help	Vor 1 week
	Filament runout - faulty filament sensors? or proper behavio... Im Forum Hardware, firmware and software help	Vor 1 week
	@eliarchercohen Thank you. I think this should get me start... Im Forum Coronavirus (COVID-19)	Vor 6 years
	Help with Stacks of RC3 face shields Im Forum Coronavirus (COVID-19)	Vor 6 years
	@bobstro - you were 100% correct about the speed/flow rate. ... Im Forum How do I print this? (Printing help)	Vor 7 years
	Fantastic, thank you for the reply. I will absolutely try t... Im Forum How do I print this? (Printing help)	Vor 7 years
	Bad surface on larger (>75mm Diameter) prints, while smal... Im Forum How do I print this? (Printing help)	Vor 7 years
	[Build Problems] E-Exis FS-Cover Assembly Issue Im Forum Assembly and first prints troubleshooting	Vor 7 years

Forums-Statistiken

595 Foren

68.8 K Themen

481.6 K Beiträge

15 Online

77.5 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen