Prusa3D Forum

Notifications

Clear all

CAR

Group: Registered

Joined: 2019/03/20

Active Member

	Thanks @Jürgen, I did actually use that info screen. It appe... In forum Hardware, firmware and software help	1 week ago
	I just checked the unit, and both the upper and lower filame... In forum Hardware, firmware and software help	1 week ago
	@chmax - Thank you for the hint. I'm heading there right now... In forum Hardware, firmware and software help	1 week ago
	Filament runout - faulty filament sensors? or proper behavio... In forum Hardware, firmware and software help	1 week ago
	@eliarchercohen Thank you. I think this should get me start... In forum Coronavirus (COVID-19)	6 years ago
	Help with Stacks of RC3 face shields In forum Coronavirus (COVID-19)	6 years ago
	@bobstro - you were 100% correct about the speed/flow rate. ... In forum How do I print this? (Printing help)	7 years ago
	Fantastic, thank you for the reply. I will absolutely try t... In forum How do I print this? (Printing help)	7 years ago
	Bad surface on larger (>75mm Diameter) prints, while smal... In forum How do I print this? (Printing help)	7 years ago
	[Build Problems] E-Exis FS-Cover Assembly Issue In forum Assembly and first prints troubleshooting	7 years ago

Forum Statistics

595 Forums

68.8 K Topics

481.5 K Posts

11 Online

77.4 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed