Notifications
Clear all
Canardiain
Canardiain
Group: Registered
Joined: 2021/03/16
Eminent Member
2
Here you go.  body49516.zip

In forum PrusaSlicer

2 years ago
Support Enforcer Not Working

In forum PrusaSlicer

2 years ago
Hi Bazim, Thank you - I think this did the trick! Before I p...

In forum Hardware, firmware and software help

2 years ago
I've also noticed this on mine, for what it's worth.

In forum Hardware, firmware and software help

2 years ago
"Crunchy" or "Loose"-sounding Extruder?

In forum Hardware, firmware and software help

2 years ago
D'oh - I just tried one of the spares supplied with the kit....

In forum Assembly and first prints troubleshooting

3 years ago
How are you supposed to get the brass thing on the end of th...

In forum Assembly and first prints troubleshooting

3 years ago
Thanks for the replies! I found this information regarding ...

In forum Assembly and first prints troubleshooting

4 years ago
Thanks for the reply. What is a cold pull, and where does o...

In forum Assembly and first prints troubleshooting

4 years ago
Any Concerns Switching Materials? (PLA > PETG > PLA > ...)

In forum Assembly and first prints troubleshooting

4 years ago
I had the same issue. I used the M3x20 screw instead of the...

In forum Assembly and first prints troubleshooting

4 years ago
I just ran into the Y axis cable issue too. I had to disass...

In forum Assembly and first prints troubleshooting

4 years ago
PEI Sheet - Protective Cover?

In forum Assembly and first prints troubleshooting

4 years ago
I just got to this step and had the same issue. There seems...

In forum Assembly and first prints troubleshooting

4 years ago
Page 2 / 2
Share: