Benachrichtigungen
Alles löschen
Buckeye Slicer
Buckeye Slicer
Gruppe: Registriert
Beigetreten: 2019/11/26
Eminent Member
2
Not sure what the error was. Something about temp. I cleared...

Im Forum How do I print this? (Printing help)

Vor 3 years
Print stopped partially through 16hr print. Need solutions

Im Forum How do I print this? (Printing help)

Vor 3 years
How Do I Change Filament Mid Print

Im Forum General discussion, announcements and releases

Vor 3 years
First Layer advice

Im Forum General discussion, announcements and releases

Vor 3 years
For some reason I cannot upgrade my Octoprint to 1.6.1 or 1....

Im Forum General discussion, announcements and releases

Vor 3 years
Got my problem solved. Washed the sheet with a generic dolla...

Im Forum General discussion, announcements and releases

Vor 3 years
I went from -0.750 to -0.875 and gave me a perfect square, p...

Im Forum General discussion, announcements and releases

Vor 3 years
Well, I guess I celebrated a little to early. Ran an STL, ba...

Im Forum General discussion, announcements and releases

Vor 3 years
One last question, that calibration gcode that Jeff Jordan m...

Im Forum General discussion, announcements and releases

Vor 3 years
Thanks everyone for your patience with me. I really apprecia...

Im Forum General discussion, announcements and releases

Vor 3 years
no you don't see any lines underneath, and yes it pulls off...

Im Forum General discussion, announcements and releases

Vor 3 years
-0.820 100% speed  16276721447907703817871929662459.j...

Im Forum General discussion, announcements and releases

Vor 3 years
Here's 3 different pictures. One picture went up to -750 at ...

Im Forum General discussion, announcements and releases

Vor 3 years
Ok, got it to stick, so we are now at -0.660, but as you can...

Im Forum General discussion, announcements and releases

Vor 3 years
I have used both alcohol, and washed with dish soap then alc...

Im Forum General discussion, announcements and releases

Vor 3 years
somewhere between -0.080 and -0.120 Back when I was having...

Im Forum General discussion, announcements and releases

Vor 3 years
Could not get PETG to stick to sheet, or adjusted. Keeps get...

Im Forum General discussion, announcements and releases

Vor 3 years
will send pic as soon as I can get one that doesn't goop up ...

Im Forum General discussion, announcements and releases

Vor 3 years
I have printed PETG, buy after I first got it, and must have...

Im Forum General discussion, announcements and releases

Vor 3 years
Not sure about this. Went down to -080 and had filament squi...

Im Forum General discussion, announcements and releases

Vor 3 years
Seite 1 / 3
Teilen: