Bruce Labitt – Aktivita

Notifications

Clear all

Bruce Labitt

Skupina: Registrovaný

Přidal se: 2023/03/12

Estimable Member

	I will post a section later in the day. I tried my Overture... In forum How do I print this? (Printing help)	před 2 years
	Another filament jam. 😥 Can't seem to catch a break on this... In forum How do I print this? (Printing help)	před 2 years
	Beginning to see a pattern here... Good prints with dry fil... In forum How do I print this? (Printing help)	před 2 years
	Yes, it is satin. Thing is, just before printing I had clea... In forum How do I print this? (Printing help)	před 2 years
	Do you know of a less expensive solution that gets that hot?... In forum How do I print this? (Printing help)	před 2 years
	Not much to see. Can't see anything obvious with a photo. ... In forum How do I print this? (Printing help)	před 2 years
	Part bowed off the sheet. There goes another attempt. Kill... In forum How do I print this? (Printing help)	před 2 years
	216C printed a little worse than 218C. Think I will stay wi... In forum How do I print this? (Printing help)	před 2 years
	My MK3S+ had better looking aligned seams than the MK4 using... In forum How do I print this? (Printing help)	před 2 years
	So like Retraction length = 1mm, rather than 1.5mm? Or 1.25... In forum How do I print this? (Printing help)	před 2 years
	Quality, (not IS) no change in MVS(5mm3/s), retraction=20mm/... In forum How do I print this? (Printing help)	před 2 years
	No gallery was attached. Jeepers. How convoluted. In forum How do I print this? (Printing help)	před 2 years
	One more try on the pictures... Trying a gallery. Why do th... In forum How do I print this? (Printing help)	před 2 years
	Don't like to sound like a Luddite, but how do you attach pi... In forum How do I print this? (Printing help)	před 2 years
	I've only asked for cost on some of the things I've done for... In forum How do I print this? (Printing help)	před 2 years
	Thanks for going through the effort of doing this! It is gr... In forum How do I print this? (Printing help)	před 2 years
	No enclosure yet. So printed out in the open. It was befor... In forum How do I print this? (Printing help)	před 2 years
	Sawed the nonIS one in half, nothing out of the ordinary (as... In forum How do I print this? (Printing help)	před 2 years
	Edit time expired: that wasn't long! Part dimensions. non I... In forum How do I print this? (Printing help)	před 2 years
	@ssill2 Printing the test model with and without IS is total... In forum How do I print this? (Printing help)	před 2 years

Stránka 6 / 9 Předchozí Další

Fórum Statistiky

595 Fóra

70 K Témata

490 K Příspěvky

17 Online

80.8 K Uživatelé

Poslední Příspěvek: Solidworks xDesign Nový Uživatel: SocialMisanthrope Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed