Prusa3D Forum

Notifiche

Cancella tutti

Bridget

Gruppo: Registrato

Registrato: 2021/12/30

Active Member

	Yeah it did it once or twice and then not again, I may have ... Nel forum Hardware, firmware and software help	3 years fa
	It is at the moment, but it had reverted twice today without... Nel forum Hardware, firmware and software help	4 years fa
	I reset the extruder to factory, then back to the right amou... Nel forum Hardware, firmware and software help	4 years fa
	Yes, the esteps value was 415, yet it extruded 76. I set it... Nel forum Hardware, firmware and software help	4 years fa
	Underextrusion after 4.3.4 firmware update Nel forum Hardware, firmware and software help	4 years fa
	Underextrusion after 4.3.4 firmware update Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

585 Forum

68 K Discussioni

476.3 K Post

12 Online

75.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso