Notifications
Clear all
Bridget
Groupe: Enregistré
A(ont) rejoint: 2021/12/30
Active Member
1
|
Yeah it did it once or twice and then not again, I may have ... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
It is at the moment, but it had reverted twice today without... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
I reset the extruder to factory, then back to the right amou... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Yes, the esteps value was 415, yet it extruded 76. I set it... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Underextrusion after 4.3.4 firmware update Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Underextrusion after 4.3.4 firmware update Dans le forum Hardware, firmware and software help |
il y a 3 years |