Avisos
Vaciar todo
Bridget
Grupo: Registrado
Registrado: 2021/12/30
Active Member
1
|
Yeah it did it once or twice and then not again, I may have ... En el foro Hardware, firmware and software help |
hace 2 years | |
|
It is at the moment, but it had reverted twice today without... En el foro Hardware, firmware and software help |
hace 3 years | |
|
I reset the extruder to factory, then back to the right amou... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Yes, the esteps value was 415, yet it extruded 76. I set it... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Underextrusion after 4.3.4 firmware update En el foro Hardware, firmware and software help |
hace 3 years | |
|
Underextrusion after 4.3.4 firmware update En el foro Hardware, firmware and software help |
hace 3 years |