Prusa3D Forum

Notifications

Clear all

Bridget

Grupa: Zarejestrowany

Dołączył: 2021/12/30

Active Member

	Yeah it did it once or twice and then not again, I may have ... In forum Hardware, firmware and software help	2 years temu
	It is at the moment, but it had reverted twice today without... In forum Hardware, firmware and software help	3 years temu
	I reset the extruder to factory, then back to the right amou... In forum Hardware, firmware and software help	3 years temu
	Yes, the esteps value was 415, yet it extruded 76. I set it... In forum Hardware, firmware and software help	3 years temu
	Underextrusion after 4.3.4 firmware update In forum Hardware, firmware and software help	3 years temu
	Underextrusion after 4.3.4 firmware update In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

559 Fora

62.8 K Tematy

442.5 K Posty

18 Online

67.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte