Prusa3D Forum

Notifications

Clear all

Bridget

Skupina: Registrovaný

Přidal se: 2021/12/30

Active Member

	Yeah it did it once or twice and then not again, I may have ... In forum Hardware, firmware and software help	před 3 years
	It is at the moment, but it had reverted twice today without... In forum Hardware, firmware and software help	před 4 years
	I reset the extruder to factory, then back to the right amou... In forum Hardware, firmware and software help	před 4 years
	Yes, the esteps value was 415, yet it extruded 76. I set it... In forum Hardware, firmware and software help	před 4 years
	Underextrusion after 4.3.4 firmware update In forum Hardware, firmware and software help	před 4 years
	Underextrusion after 4.3.4 firmware update In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

585 Fóra

68 K Témata

476.3 K Příspěvky

11 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed