|
I don't understand why the thickness was greater when I used... In forum Hardware, firmware and software help |
4 years temu |
|
adjusting the z offset to -1.1 (~0.21 mm thick square) or -1... In forum Hardware, firmware and software help |
4 years temu |
|
The arrow in the first picture shows where the filament thin... In forum Hardware, firmware and software help |
4 years temu |
|
It started as a clog. But I no longer think it can be a clog... In forum Hardware, firmware and software help |
4 years temu |
|
I don't understand why I would need to heat the nozzle (nowh... In forum Hardware, firmware and software help |
4 years temu |
|
First layer calibration problem In forum Hardware, firmware and software help |
4 years temu |
|
Problem solved. Thanks guy-k2. I tried to download the MK3S ... In forum Hardware, firmware and software help |
5 years temu |
|
I reset all data. I got the beep this time when I pressed th... In forum Hardware, firmware and software help |
5 years temu |
|
Thanks, I had that problem when I first assembled it (more o... In forum Hardware, firmware and software help |
5 years temu |
|
I tried resetting to 'factory' settings. I got more of a cli... In forum Hardware, firmware and software help |
5 years temu |
|
I tried resetting the height twice and verified a good heigh... In forum Hardware, firmware and software help |
5 years temu |
|
Z-axis calibration In forum Hardware, firmware and software help |
5 years temu |
