|
I don't understand why the thickness was greater when I used... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
adjusting the z offset to -1.1 (~0.21 mm thick square) or -1... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
The arrow in the first picture shows where the filament thin... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
It started as a clog. But I no longer think it can be a clog... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I don't understand why I would need to heat the nozzle (nowh... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
First layer calibration problem Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Problem solved. Thanks guy-k2. I tried to download the MK3S ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I reset all data. I got the beep this time when I pressed th... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thanks, I had that problem when I first assembled it (more o... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I tried resetting to 'factory' settings. I got more of a cli... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I tried resetting the height twice and verified a good heigh... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Z-axis calibration Dans le forum Hardware, firmware and software help |
il y a 5 years |
