|
I don't understand why the thickness was greater when I used... En el foro Hardware, firmware and software help |
hace 4 years |
|
adjusting the z offset to -1.1 (~0.21 mm thick square) or -1... En el foro Hardware, firmware and software help |
hace 4 years |
|
The arrow in the first picture shows where the filament thin... En el foro Hardware, firmware and software help |
hace 4 years |
|
It started as a clog. But I no longer think it can be a clog... En el foro Hardware, firmware and software help |
hace 4 years |
|
I don't understand why I would need to heat the nozzle (nowh... En el foro Hardware, firmware and software help |
hace 4 years |
|
First layer calibration problem En el foro Hardware, firmware and software help |
hace 4 years |
|
Problem solved. Thanks guy-k2. I tried to download the MK3S ... En el foro Hardware, firmware and software help |
hace 6 years |
|
I reset all data. I got the beep this time when I pressed th... En el foro Hardware, firmware and software help |
hace 6 years |
|
Thanks, I had that problem when I first assembled it (more o... En el foro Hardware, firmware and software help |
hace 6 years |
|
I tried resetting to 'factory' settings. I got more of a cli... En el foro Hardware, firmware and software help |
hace 6 years |
|
I tried resetting the height twice and verified a good heigh... En el foro Hardware, firmware and software help |
hace 6 years |
|
Z-axis calibration En el foro Hardware, firmware and software help |
hace 6 years |
