Bill W – Activité – Prusa3D Forum

Notifications

Clear all

Bill W

Groupe: Enregistré

A(ont) rejoint: 2016/07/28

Trusted Member

	There are several here. The solutions are also varied. One t... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I had the same experience last night with some clear eSun PE... Dans le forum Print tips (Archive)	il y a 8 years
	When I run my bed at 70C I don't have any trouble getting th... Dans le forum Print tips (Archive)	il y a 8 years
	Brilliant! I've just printed the latest version and it's per... Dans le forum Improvements (Archive)	il y a 8 years
	I haven't gotten back to it yet to investigate but I have ha... Dans le forum Others (Archive)	il y a 8 years
	I've had great luck with PETG, most recently the eSun versio... Dans le forum Print tips (Archive)	il y a 8 years
	I've had excellent results with using 0.15 first layer heigh... Dans le forum Print tips (Archive)	il y a 8 years
	I have changed the extruder and bed temps in the calibration... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	If you come by I will be very happy to give you some. It rea... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	E3D has socks for the extruder Dans le forum Print tips (Archive)	il y a 8 years
	Ok, I just printed the protector in PETG scaled down to 96%.... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I had similar breakage with a different thing I was printing... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Filament jammed during print - need some advice SOLVED! Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I updated to 3.0.8 this morning without incident but I did h... Dans le forum Others (Archive)	il y a 8 years
	I've been using MadeSolid's PET+ which I suspect is a versio... Dans le forum Print tips (Archive)	il y a 8 years
	Well, I am using Simplify3d 3.1.0 with firmware 3.0.7 very s... Dans le forum General discussion, announcements and releases	il y a 8 years
	Nozzle crud? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Ice cream cone holder Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	I have a Pi 3 which I had already set up with the Picamera s... Dans le forum Software (Archive)	il y a 8 years
	I got Octoprint up on the Pi and it's wonderful! I even sign... Dans le forum Software (Archive)	il y a 8 years

Page 3 / 4 Précédent Suivant

Statistiques du forum

559 Forums

62.8 K Sujets

442.6 K Messages

18 En-ligne

67.4 K Membres

Le dernier des messages: print fading as it goes up and to the right Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé