Bill W – Activité – Prusa3D Forum

Notifications

Clear all

Bill W

Groupe: Enregistré

A(ont) rejoint: 2016/07/28

Trusted Member

	Definitely a problem in the gcode! Dans le forum Others (Archive)	il y a 8 years
	I was noticing the buildup on the nozzle and had taken to us... Dans le forum Others (Archive)	il y a 8 years
	Post the problem GCODE and we can look at it in a previewer.... Dans le forum Others (Archive)	il y a 8 years
	I use both MadeSolid PET+ and eSun PETG. Both print very wel... Dans le forum Others (Archive)	il y a 8 years
	@ruben.h Yes, I would say that the S3D profile is ready for ... Dans le forum General discussion, announcements and releases	il y a 8 years
	... Just another way to get the geeks like me happy and have... Dans le forum Others (Archive)	il y a 8 years
	I was able to slip the sock under the thermistor cable with ... Dans le forum Improvements (Archive)	il y a 8 years
	Have you posted the design files? I don't see them on Thingi... Dans le forum Improvements (Archive)	il y a 8 years
	Manuel, you can tell if you have the new version by looking ... Dans le forum Improvements (Archive)	il y a 8 years
	From the M303 I got: Kp: 20.05 Ki: 1.34 Kd: 75.15 Dans le forum Improvements (Archive)	il y a 8 years
	I just installed the sock from Filastruder. My limited testi... Dans le forum Others (Archive)	il y a 8 years
	I was going to look into that. There is a thread here about ... Dans le forum Improvements (Archive)	il y a 8 years
	Got my socks on! Dans le forum Improvements (Archive)	il y a 8 years
	Here's a print I just created: G90 M83 M106 S0 M140 S50... Dans le forum Print tips (Archive)	il y a 8 years
	I just ran a test during one of my prints and the fan at 75%... Dans le forum Others (Archive)	il y a 8 years
	There is a setting on the Temperature tab which says "Wait f... Dans le forum Print tips (Archive)	il y a 8 years
	I have been paying a bit more attention to temperatures late... Dans le forum Others (Archive)	il y a 8 years
	I suggest you post over in the Octoprint Google+ or Google G... Dans le forum Software (Archive)	il y a 8 years
	Thanks Christophe ,can you give me a link or recommend any s... Dans le forum Software (Archive)	il y a 8 years
	Anyone had any success with Z-hop at all? I've had some succ... Dans le forum General discussion, announcements and releases	il y a 8 years

Page 2 / 4 Précédent Suivant

Statistiques du forum

559 Forums

62 K Sujets

438.7 K Messages

17 En-ligne

67.1 K Membres

Le dernier des messages: Network Error bei Prusa Connect Notre nouveau membre: Phoenix 3D Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé