Bill W – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

Bill W

Gruppe: Registriert

Beigetreten: 2016/07/28

Trusted Member

	Definitely a problem in the gcode! Im Forum Others (Archive)	Vor 8 years
	I was noticing the buildup on the nozzle and had taken to us... Im Forum Others (Archive)	Vor 8 years
	Post the problem GCODE and we can look at it in a previewer.... Im Forum Others (Archive)	Vor 8 years
	I use both MadeSolid PET+ and eSun PETG. Both print very wel... Im Forum Others (Archive)	Vor 8 years
	@ruben.h Yes, I would say that the S3D profile is ready for ... Im Forum General discussion, announcements and releases	Vor 8 years
	... Just another way to get the geeks like me happy and have... Im Forum Others (Archive)	Vor 8 years
	I was able to slip the sock under the thermistor cable with ... Im Forum Improvements (Archive)	Vor 8 years
	Have you posted the design files? I don't see them on Thingi... Im Forum Improvements (Archive)	Vor 8 years
	Manuel, you can tell if you have the new version by looking ... Im Forum Improvements (Archive)	Vor 8 years
	From the M303 I got: Kp: 20.05 Ki: 1.34 Kd: 75.15 Im Forum Improvements (Archive)	Vor 8 years
	I just installed the sock from Filastruder. My limited testi... Im Forum Others (Archive)	Vor 8 years
	I was going to look into that. There is a thread here about ... Im Forum Improvements (Archive)	Vor 8 years
	Got my socks on! Im Forum Improvements (Archive)	Vor 8 years
	Here's a print I just created: G90 M83 M106 S0 M140 S50... Im Forum Print tips (Archive)	Vor 8 years
	I just ran a test during one of my prints and the fan at 75%... Im Forum Others (Archive)	Vor 8 years
	There is a setting on the Temperature tab which says "Wait f... Im Forum Print tips (Archive)	Vor 8 years
	I have been paying a bit more attention to temperatures late... Im Forum Others (Archive)	Vor 8 years
	I suggest you post over in the Octoprint Google+ or Google G... Im Forum Software (Archive)	Vor 8 years
	Thanks Christophe ,can you give me a link or recommend any s... Im Forum Software (Archive)	Vor 8 years
	Anyone had any success with Z-hop at all? I've had some succ... Im Forum General discussion, announcements and releases	Vor 8 years

Seite 2 / 4 Vorherige Nächstes

Forums-Statistiken

559 Foren

63.1 K Themen

443.9 K Beiträge

22 Online

68.1 K Mitglieder

Letzter Beitrag: Microscopic bed leveling damage? Unser neuestes Mitglied: etiennep Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen