Prusa3D Forum

Notifications

Clear all

Ben

Groupe: Enregistré

A(ont) rejoint: 2016/06/22

Reputable Member

	> Wrong. This type of misaligned geometry is NOT sorted o... Dans le forum Others (Archive)	il y a 8 years
	No way! That went ages ago. I see its still for sale for a... Dans le forum Others (Archive)	il y a 8 years
	link fixed. looks good though 😉 Dans le forum Improvements (Archive)	il y a 8 years
	I think it is either heat or poor retraction/extruding. I am... Dans le forum Others (Archive)	il y a 8 years
	I thought exactly the same when I ordered it. Prusa seem to ... Dans le forum Others (Archive)	il y a 8 years
	If I ever get problems I just swap out the nozzle. It tends ... Dans le forum Others (Archive)	il y a 8 years
	How old is the filament? Did you used to get good prints bef... Dans le forum Others (Archive)	il y a 8 years
	Next step is take the entire hot end out of the extruder bod... Dans le forum Others (Archive)	il y a 8 years
	Great news buddy. Thanks for the heads up. Enjoy printing ... Dans le forum Others (Archive)	il y a 8 years
	Nice one Gordon 😉 I guess they could make a universal h... Dans le forum Others (Archive)	il y a 8 years
	Part blockage looking at the numbers. I had this for a few d... Dans le forum Others (Archive)	il y a 8 years
	Or copy the holes and then mount the Multiplex to the Pi cas... Dans le forum Others (Archive)	il y a 8 years
	I was talking about Jame's 😉 Dans le forum Others (Archive)	il y a 8 years
	I feel your rant. I waited over 5 weeks when it was 3-4 week... Dans le forum Others (Archive)	il y a 8 years
	I think there is a good reason there is not a classified sec... Dans le forum Others (Archive)	il y a 8 years
	Yes holes already on the frame for mounting the board and ca... Dans le forum Others (Archive)	il y a 8 years
	It went a long tome ago now. 😉 Dans le forum Others (Archive)	il y a 8 years
	I did that and they sorted it. Odd because Live chat told me... Dans le forum Others (Archive)	il y a 8 years
	I agree it probably has nothing to do with the lean Peter bu... Dans le forum Others (Archive)	il y a 8 years
	Nice one. Thanks for the update 😉 Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 1 / 16 Suivant

Statistiques du forum

565 Forums

63.8 K Sujets

447.5 K Messages

24 En-ligne

69.5 K Membres

Le dernier des messages: Content ??? ou ? Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé