Notifications
Clear all
ben.g16
ben.g16
Skupina: Registrovaný
Přidal se: 2018/07/18
Estimable Member
4
Ok, found the problem. My mistake. I put a spool of PETG i...

In forum Hardware, firmware and software help

před 4 years
Second layer failure

In forum Hardware, firmware and software help

před 4 years
VW is straight CAD, mainly for Architects. I am doing engine...

In forum PrusaSlicer

před 4 years
@neophyl Thanks for your review. I am printing a previous v...

In forum PrusaSlicer

před 4 years
OK, let’s try this again. Zip file prepared. Don't see tha...

In forum PrusaSlicer

před 4 years
I have tried twice to use the Attach File / Choose File belo...

In forum PrusaSlicer

před 4 years
Be glad to post files. The CAD is Vectorworks, version 2020...

In forum PrusaSlicer

před 4 years
I am having the same problem, only worse - and one more. My...

In forum PrusaSlicer

před 4 years
The forum lost the pic. Here it is. (This is a cancelled p...

In forum Hardware, firmware and software help

před 5 years
I think I found a solution for the outside wall layer shifti...

In forum Hardware, firmware and software help

před 5 years
OK, figured it out. Whenever I post a problem my mind kicks...

In forum Hardware, firmware and software help

před 5 years
Slicer Gaps

In forum Hardware, firmware and software help

před 5 years
I may not have been clear. Pic #1 is the upright orientatio...

In forum PrusaSlicer

před 5 years
Separate suports on object

In forum PrusaSlicer

před 5 years
I have the same problem, but I have found it is associated w...

In forum Hardware, firmware and software help

před 5 years
@robert-rmm200 Couldn’t find the PSU on the site. The quote...

In forum Hardware, firmware and software help

před 5 years
Sorry for the repeat - this site doesn’t deal with pictures ...

In forum Hardware, firmware and software help

před 5 years
@karl-herbert Thanks for all the suggestions. As I searched...

In forum Hardware, firmware and software help

před 5 years
OK, after searching in vain for a wiring diagram for the PS ...

In forum Hardware, firmware and software help

před 5 years
The power supply on my MK3/S just went out. I was printing ...

In forum Hardware, firmware and software help

před 5 years
Stránka 3 / 6
Share: