Notifications
Clear all
ben.g16
ben.g16
Skupina: Registrovaný
Přidal se: 2018/07/18
Estimable Member
4
Turns out to be the software. After turning the unit on and...

In forum General discussion, announcements and releases

před 5 years
As you might be able to see, my object is rather complicated...

In forum Hardware, firmware and software help

před 5 years
support blocker not working

In forum Hardware, firmware and software help

před 5 years
I have never been able to get filament autoload to work. It...

In forum Hardware, firmware and software help

před 5 years
MK3 wont restart after filament outage

In forum Hardware, firmware and software help

před 5 years
Tim, Thanks for the info. Would you mind posting your Suppo...

In forum General discussion, announcements and releases

před 5 years
Thanks. I was looking only for a -S/Y tensioner update, not...

In forum Hardware, firmware and software help

před 5 years
Thanks. I was looking only for a -S/Y tensioner update, not...

In forum Hardware, firmware and software help

před 5 years
Unfortunately, I have the original MK3 with add on S upgrade...

In forum Hardware, firmware and software help

před 5 years
Can you point me to the Prusa site with the updated dwgs? I...

In forum Hardware, firmware and software help

před 5 years
I too have spent the better part of 6 months trying to get s...

In forum General discussion, announcements and releases

před 5 years
OK, it seems there are two mindsets for printing multiple ob...

In forum How do I print this? (Printing help)

před 5 years
After all the hassle and good advice, I finally found the cu...

In forum General discussion, announcements and releases

před 5 years
Pronterface was not included in my Prusa's "software & d...

In forum How do I print this? (Printing help)

před 5 years
Milo, It is true that PrusaSlicer allows you to set the ext...

In forum How do I print this? (Printing help)

před 5 years
I have three objects on the print bed. I want to print one ...

In forum How do I print this? (Printing help)

před 5 years
printing individual objects

In forum How do I print this? (Printing help)

před 5 years
Tim was right about the Z layer. I changed filament and sta...

In forum General discussion, announcements and releases

před 5 years
Result: The boundaries printed well at startup, but the fil...

In forum General discussion, announcements and releases

před 5 years
ONE year old. Dont have any grit residue. Remember, I have...

In forum General discussion, announcements and releases

před 5 years
Stránka 4 / 6
Share: