Čeština
Fóra
Uživatelé
Bavilo
Aktivita
 
Notifications
Clear all
Bavilo
Bavilo
Skupina: Registrovaný
Přidal se: 2017/02/01
Eminent Member
2
Profile Aktivita
The RJZM-01-08 are press fitted as well, but they have an ou...

In forum Others (Archive)

 před 9 years
Thanks! I will get RJZM-02-08 then!

In forum Others (Archive)

 před 9 years
Prusa is kindly sending me new rods and bearings. Will see h...

In forum Others (Archive)

 před 9 years
Disassembled the Y Axis today and took a look at the rods an...

In forum Others (Archive)

 před 9 years
10x10x10mm cube almost good

In forum Print tips (Archive)

 před 9 years
I do have the MK2S kit. And sadly I can't take a detailed en...

In forum Others (Archive)

 před 9 years
I have printed a Benchy and I think the results are good.

In forum Assembly and first prints troubleshooting

 před 9 years
I will try to take a picture tomorrow. I will also try some ...

In forum Others (Archive)

 před 9 years
Y-Axis is making a "scratching" noise

In forum Others (Archive)

 před 9 years
Ok so this is how I did it now... LCD and PSU are outside o...

In forum Improvements (Archive)

 před 9 years
Yea I think so too. Currently printing the Whistle which cam...

In forum Assembly and first prints troubleshooting

 před 9 years
Last two pics:

In forum Assembly and first prints troubleshooting

 před 9 years
Ok so calibration is done. I believe I was spot on with 525...

In forum Assembly and first prints troubleshooting

 před 9 years
curently doing the calibration. I hve one question though.....

In forum Assembly and first prints troubleshooting

 před 9 years
Prusa i3 MK2S PSU placeholder bracket?

In forum Others (Archive)

 před 9 years
Question about MK2 enclosures

In forum Improvements (Archive)

 před 9 years
The back is 100% smooth. I will measure the thickness when I...

In forum Prusa i3 kit (Archive)

 před 9 years
Is this first layer good?

In forum Prusa i3 kit (Archive)

 před 9 years
Stránka 2 / 2
Share: