Prusa3D Forum

Notifications

Clear all

Axel

Grupa: Zarejestrowany

Dołączył: 2023/03/12

Active Member

	Printed one set of halves and while I can go fast, there was... In forum Hardware, firmware and software help	2 years temu
	Getting the nozzles takes a week, and the few I've printed s... In forum Hardware, firmware and software help	2 years temu
	Thanks, I read it and while I print in PLA it mentions some ... In forum Hardware, firmware and software help	2 years temu
	The first prints did print perfectly with the default profil... In forum Hardware, firmware and software help	2 years temu
	Tried another test, this time dropped extrusion width to 0.4... In forum Hardware, firmware and software help	2 years temu
	Drooping exterior perimeter In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

567 Fora

64.9 K Tematy

453.8 K Posty

19 Online

71.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte