Notifications
Clear all
Axel
Groupe: Enregistré
A(ont) rejoint: 2023/03/12
Active Member
1
|
Printed one set of halves and while I can go fast, there was... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Getting the nozzles takes a week, and the few I've printed s... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Thanks, I read it and while I print in PLA it mentions some ... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
The first prints did print perfectly with the default profil... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Tried another test, this time dropped extrusion width to 0.4... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Drooping exterior perimeter Dans le forum Hardware, firmware and software help |
il y a 2 years |