Prusa3D Forum

Notifiche

Cancella tutti

Axel

Gruppo: Registrato

Registrato: 2023/03/12

Active Member

	Printed one set of halves and while I can go fast, there was... Nel forum Hardware, firmware and software help	2 years fa
	Getting the nozzles takes a week, and the few I've printed s... Nel forum Hardware, firmware and software help	2 years fa
	Thanks, I read it and while I print in PLA it mentions some ... Nel forum Hardware, firmware and software help	2 years fa
	The first prints did print perfectly with the default profil... Nel forum Hardware, firmware and software help	2 years fa
	Tried another test, this time dropped extrusion width to 0.4... Nel forum Hardware, firmware and software help	2 years fa
	Drooping exterior perimeter Nel forum Hardware, firmware and software help	2 years fa

Statistiche Forum

567 Forum

64.9 K Discussioni

453.8 K Post

19 Online

71.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso