Attività
 
Notifiche
Cancella tutti
atish8888
atish8888
Gruppo: Registrato
Registrato: 2020/09/24
Active Member
1
@tim-m30 Thanks for the help this morning. You put my mind a...

Nel forum General discussion, announcements and releases

4 years fa
Ok issue resolved. Thank you Tim and neophyl. So this is wh...

Nel forum General discussion, announcements and releases

4 years fa
@tim-m30 Thank you for the reply. I did have a look at a few...

Nel forum General discussion, announcements and releases

4 years fa
Hot end not getting to temperature.

Nel forum General discussion, announcements and releases

4 years fa
@fuchsr You my friend have made my tinkering lifestyle much ...

Nel forum General discussion, announcements and releases

4 years fa
@neophyl Good tip about extrusion width being small than noz...

Nel forum General discussion, announcements and releases

4 years fa
Is it possible to use a wider extrusion width for the body o...

Nel forum General discussion, announcements and releases

4 years fa
@neophyl Thanks! I have got this now. Looks quite detailed s...

Nel forum General discussion, announcements and releases

4 years fa
@fuchsr They were some comprehensive tips right there! The D...

Nel forum General discussion, announcements and releases

4 years fa
Sure, I will check it out now!

Nel forum General discussion, announcements and releases

4 years fa
Oh dear, I feel quite silly. Thank you for pointing this ou...

Nel forum General discussion, announcements and releases

4 years fa
Please see below, I have attached the file. Bear in mind th...

Nel forum General discussion, announcements and releases

4 years fa
This is what I thought. I have been working all day, let me ...

Nel forum General discussion, announcements and releases

4 years fa
Simple CAD design giving me slicing issues

Nel forum General discussion, announcements and releases

4 years fa
@torbjorn-j3 Absolutely my friend. I meant 0.25mm

Nel forum General discussion, announcements and releases

4 years fa
Thank you so much for that information,. At lunch time today...

Nel forum General discussion, announcements and releases

4 years fa
RE: Lettering not filled in fully

Nel forum General discussion, announcements and releases

4 years fa
Lettering not filled in fully

Nel forum General discussion, announcements and releases

4 years fa
Condividi: