Notifications
Clear all
atish8888
atish8888
Skupina: Registrovaný
Přidal se: 2020/09/24
Active Member
1
@tim-m30 Thanks for the help this morning. You put my mind a...

In forum General discussion, announcements and releases

před 4 years
Ok issue resolved. Thank you Tim and neophyl. So this is wh...

In forum General discussion, announcements and releases

před 4 years
@tim-m30 Thank you for the reply. I did have a look at a few...

In forum General discussion, announcements and releases

před 4 years
Hot end not getting to temperature.

In forum General discussion, announcements and releases

před 4 years
@fuchsr You my friend have made my tinkering lifestyle much ...

In forum General discussion, announcements and releases

před 4 years
@neophyl Good tip about extrusion width being small than noz...

In forum General discussion, announcements and releases

před 4 years
Is it possible to use a wider extrusion width for the body o...

In forum General discussion, announcements and releases

před 4 years
@neophyl Thanks! I have got this now. Looks quite detailed s...

In forum General discussion, announcements and releases

před 4 years
@fuchsr They were some comprehensive tips right there! The D...

In forum General discussion, announcements and releases

před 4 years
Sure, I will check it out now!

In forum General discussion, announcements and releases

před 4 years
Oh dear, I feel quite silly. Thank you for pointing this ou...

In forum General discussion, announcements and releases

před 4 years
Please see below, I have attached the file. Bear in mind th...

In forum General discussion, announcements and releases

před 4 years
This is what I thought. I have been working all day, let me ...

In forum General discussion, announcements and releases

před 4 years
Simple CAD design giving me slicing issues

In forum General discussion, announcements and releases

před 4 years
@torbjorn-j3 Absolutely my friend. I meant 0.25mm

In forum General discussion, announcements and releases

před 4 years
Thank you so much for that information,. At lunch time today...

In forum General discussion, announcements and releases

před 4 years
RE: Lettering not filled in fully

In forum General discussion, announcements and releases

před 4 years
Lettering not filled in fully

In forum General discussion, announcements and releases

před 4 years
Share: