Armin – Activity – Prusa3D Forum

Notifications

Clear all

Armin

Group: Registered

Joined: 2022/07/17

Eminent Member

	Randomly distributed small holes/gaps in my PLA model? In forum How do I print this? (Printing help)	2 years ago
	Thanks and what do you mean to 2.)? In forum How do I print this? (Printing help)	2 years ago
	More Stringing with heigher extrusion width? In forum How do I print this? (Printing help)	2 years ago
	Thanks, tried a lot, see below. Haven't done anything with t... In forum How do I print this? (Printing help)	2 years ago
	Here are my settings: Printer settings:Retraction length: 2-... In forum How do I print this? (Printing help)	2 years ago
	I attached the .3mf. Hopefully someone find something wrong.... In forum How do I print this? (Printing help)	2 years ago
	Yes, I attached one below. In forum How do I print this? (Printing help)	2 years ago
	The upper diameter is 5mm. In forum How do I print this? (Printing help)	2 years ago
	Yes but the problem was since the purchase of the eSun filam... In forum How do I print this? (Printing help)	2 years ago
	Yes, I have small boxes with silica, ~35% humidity. In forum How do I print this? (Printing help)	2 years ago
	Yes I have set Prusa Slicer to expert mode otherwise I think... In forum How do I print this? (Printing help)	2 years ago
	Stringing on mk3s+ with eSun TPU 95a at transitions? In forum How do I print this? (Printing help)	2 years ago
	Yes, I also think that you have to try different thread tole... In forum How do I print this? (Printing help)	2 years ago
	Thread tolerances on Prusa mk3s+? In forum How do I print this? (Printing help)	2 years ago

Page 2 / 2 Prev

Forum Statistics

565 Forums

63.5 K Topics

446 K Posts

20 Online

68.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed