Prusa3D Forum

Notifications

Clear all

Argh

Skupina: Registrovaný

Přidal se: 2020/05/25

Active Member

	I agree, i measure them at 1.54mm which is off enough to cau... In forum Hardware, firmware and software help	před 4 years
	I agree, i measure them at 1.54mm which is off enough to cau... In forum Hardware, firmware and software help	před 4 years
	Just wanted to add my experience with this issue. I had the ... In forum Hardware, firmware and software help	před 4 years
	I just started printing with the Prusament PC Blend in the l... In forum General discussion, announcements and releases	před 4 years
	Do you think this one would work? Specs are close bit a bit ... In forum Hardware, firmware and software help	před 4 years
	Do you think this one would work? Specs are similar, rpm 830... In forum User mods - OctoPrint, enclosures, nozzles, ...	před 4 years

Fórum Statistiky

559 Fóra

63 K Témata

443.1 K Příspěvky

20 Online

67.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed