Prusa3D Forum

Notifications

Clear all

Argh

Grupa: Zarejestrowany

Dołączył: 2020/05/25

Active Member

	I agree, i measure them at 1.54mm which is off enough to cau... In forum Hardware, firmware and software help	4 years temu
	I agree, i measure them at 1.54mm which is off enough to cau... In forum Hardware, firmware and software help	4 years temu
	Just wanted to add my experience with this issue. I had the ... In forum Hardware, firmware and software help	4 years temu
	I just started printing with the Prusament PC Blend in the l... In forum General discussion, announcements and releases	4 years temu
	Do you think this one would work? Specs are close bit a bit ... In forum Hardware, firmware and software help	4 years temu
	Do you think this one would work? Specs are similar, rpm 830... In forum User mods - OctoPrint, enclosures, nozzles, ...	4 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.1 K Posty

20 Online

67.8 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte