AnneVanLeyden – Aktivita

Notifications

Clear all

AnneVanLeyden

Skupina: Registrovaný

Přidal se: 2023/05/18

Trusted Member

	Mein erster Versuch mit Greentec Pro verlief nicht gut. Mein... In forum Wie drucke ich das? (Hilfe zum Drucken)	před 3 years
	I use a glue stick for all my prints. Also PLA on smooth PEI... In forum How do I print this? (Printing help)	před 3 years
	The extruder temp dropped from 52° to 42° Obviously, I m... In forum How do I print this? (Printing help)	před 3 years
	[Solved] Filament jams each time at same point In forum How do I print this? (Printing help)	před 3 years
	This is pretty common. The higher layers will shrink slightl... In forum How do I print this? (Printing help)	před 3 years
	It's a combination of the Y acceleration and slight drag fro... In forum How do I print this? (Printing help)	před 3 years
	Thank you all for all the help and suggestions! At least I k... In forum PrusaSlicer	před 3 years
	I am already removing the M600 from the GCODE. But I'd like ... In forum PrusaSlicer	před 3 years
	Sorry, I didn't look right. When doing a 'simple color chang... In forum PrusaSlicer	před 3 years
	But most of the time, the correct filament is already loaded... In forum PrusaSlicer	před 3 years
	Do you have to enable this setting somewhere? I am now using... In forum PrusaSlicer	před 3 years
	Manual multicolor printing: unnecessary M600 at start In forum PrusaSlicer	před 3 years

Stránka 3 / 3 Předchozí

Fórum Statistiky

613 Fóra

72 K Témata

505.5 K Příspěvky

14 Online

83.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed