Amoda – Aktivita – Prusa3D Forum

Notifications

Clear all

Amoda

Skupina: Registrovaný

Přidal se: 2022/01/11

Eminent Member

	Thanks, see attached. Though this attached version was my ov... In forum How do I print this? (Printing help)	před 3 years
	Well, the supports released, but they also failed to support... In forum How do I print this? (Printing help)	před 3 years
	I'll fiddle with those settings a bit. I haven't had this is... In forum How do I print this? (Printing help)	před 3 years
	Can you clarify. A contact distance of 0.25 seems like a lot... In forum How do I print this? (Printing help)	před 3 years
	Issues with bottom of supports sticking to my model In forum How do I print this? (Printing help)	před 3 years
	What were your other support settings? (such as interface la... In forum How do I print this? (Printing help)	před 3 years
	If its any consolation. I think the print lines add to the m... In forum How do I print this? (Printing help)	před 3 years
	I have found printing with a few raft layers helps, even for... In forum Hardware, firmware and software help	před 3 years
	Much appreciated. I've been happy with my results in general... In forum How do I print this? (Printing help)	před 3 years
	Thanks for the additional insights. With your settings do yo... In forum How do I print this? (Printing help)	před 3 years
	Thanks. It helps to understand that this feature is a legacy... In forum How do I print this? (Printing help)	před 3 years
	Can someone help me better understand interface loops? In forum How do I print this? (Printing help)	před 3 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

559 Fóra

63.1 K Témata

443.8 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed