Activity
 
Notifications
Clear all
altaic
altaic
Group: Registered
Joined: 2025/02/17
Trusted Member
3
Something just occurred to me. I believe PrusaSlicer 2.9.2 c...

In forum Hardware, firmware and software help

5 months ago
Thanks so much for testing! I also noticed what you’re descr...

In forum Hardware, firmware and software help

5 months ago
Certainly, I zipped up the gcode and 3mf for you.  11...

In forum Hardware, firmware and software help

5 months ago
That occurred to me as well, though I’m going to step away f...

In forum Hardware, firmware and software help

5 months ago
Arc fitting is and has been on and avoid crossing perimeters...

In forum Hardware, firmware and software help

5 months ago
It’s the same gcode I used before, and shouldn’t have those ...

In forum Hardware, firmware and software help

5 months ago
Oh, the Y-axis seized and the X-axis kept moving in the -X d...

In forum Hardware, firmware and software help

5 months ago
Yeah it’s a high speced STM32F4. Perhaps an STM32H-series wo...

In forum User mods

5 months ago
So my newest VFA test from 170 mm/s to 200 mm/s failed durin...

In forum Hardware, firmware and software help

5 months ago
I followed the directions in a post here from Prusa support'...

In forum Hardware, firmware and software help

5 months ago
That was what I was thinking, but it's not clear to me since...

In forum Hardware, firmware and software help

5 months ago
Just following up after straightening the gantry and tension...

In forum Hardware, firmware and software help

5 months ago
Hmmm -__-

In forum General discussion, announcements and releases

5 months ago
Please no, that is a misuse of gcode. Just use a settings fi...

In forum General discussion, announcements and releases

5 months ago
As far as the input shaping procedure goes, the frequency di...

In forum Hardware, firmware and software help

5 months ago
In my case, the metal cover for the wiring on the upper back...

In forum Hardware, firmware and software help

5 months ago
Yes, it appears so, however as I noted the code uses implici...

In forum Hardware, firmware and software help

5 months ago
So, the code is in `lib/Marlin/Marlin/src/feature/input_shap...

In forum Hardware, firmware and software help

5 months ago
I think X and Y directly refer to the motors, not the cartes...

In forum Hardware, firmware and software help

5 months ago
In theory that's how it should work, but I suspect that if o...

In forum Assembly and first prints troubleshooting

5 months ago
Page 2 / 5
Share: