|
Something just occurred to me. I believe PrusaSlicer 2.9.2 c... En el foro Hardware, firmware and software help |
hace 10 months |
|
Thanks so much for testing! I also noticed what you’re descr... En el foro Hardware, firmware and software help |
hace 10 months |
|
Certainly, I zipped up the gcode and 3mf for you.
11... En el foro Hardware, firmware and software help |
hace 10 months |
|
That occurred to me as well, though I’m going to step away f... En el foro Hardware, firmware and software help |
hace 10 months |
|
Arc fitting is and has been on and avoid crossing perimeters... En el foro Hardware, firmware and software help |
hace 10 months |
|
It’s the same gcode I used before, and shouldn’t have those ... En el foro Hardware, firmware and software help |
hace 10 months |
|
Oh, the Y-axis seized and the X-axis kept moving in the -X d... En el foro Hardware, firmware and software help |
hace 10 months |
|
Yeah it’s a high speced STM32F4. Perhaps an STM32H-series wo... En el foro User mods |
hace 10 months |
|
So my newest VFA test from 170 mm/s to 200 mm/s failed durin... En el foro Hardware, firmware and software help |
hace 10 months |
|
I followed the directions in a post here from Prusa support'... En el foro Hardware, firmware and software help |
hace 10 months |
|
That was what I was thinking, but it's not clear to me since... En el foro Hardware, firmware and software help |
hace 10 months |
|
Just following up after straightening the gantry and tension... En el foro Hardware, firmware and software help |
hace 10 months |
|
Hmmm -__- En el foro General discussion, announcements and releases |
hace 10 months |
|
Please no, that is a misuse of gcode. Just use a settings fi... En el foro General discussion, announcements and releases |
hace 10 months |
|
As far as the input shaping procedure goes, the frequency di... En el foro Hardware, firmware and software help |
hace 10 months |
|
In my case, the metal cover for the wiring on the upper back... En el foro Hardware, firmware and software help |
hace 10 months |
|
Yes, it appears so, however as I noted the code uses implici... En el foro Hardware, firmware and software help |
hace 10 months |
|
So, the code is in `lib/Marlin/Marlin/src/feature/input_shap... En el foro Hardware, firmware and software help |
hace 10 months |
|
I think X and Y directly refer to the motors, not the cartes... En el foro Hardware, firmware and software help |
hace 10 months |
|
In theory that's how it should work, but I suspect that if o... En el foro Assembly and first prints troubleshooting |
hace 10 months |
