Avisos
Vaciar todo
Alphonse
Grupo: Registrado
Registrado: 2021/07/19
Active Member
1
|
Understand that this printer shakes a table badly if it is n... En el foro User mods |
hace 4 months | |
| @cjd, Did you get the bill for the tariff from FedEx after t... | hace 4 months | |
|
Thanks for the great write up and photos! Well done. En el foro Assembly and first prints troubleshooting |
hace 4 months | |
|
Thanks @languer - that's got to be the root cause of the iss... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Noisy Z when head is near print plate En el foro Hardware, firmware and software help |
hace 3 years | |
|
Thanks for the insights and advice. I appreciate your respon... En el foro How do I print this? (Printing help) |
hace 4 years | |
|
Maybe since my post had to be approved by a moderator, it dr... En el foro How do I print this? (Printing help) |
hace 4 years | |
|
Cobwebs on my print!! En el foro How do I print this? (Printing help) |
hace 4 years | |
| Mine is close to bumping the allowable limit at -1.850 mm. ... | hace 4 years |