alejo.v2 – Activité – Prusa3D Forum

Notifications

Clear all

alejo.v2

Groupe: Enregistré

A(ont) rejoint: 2018/06/21

Eminent Member

	I apply the glue when the bed is hot. And used 100°C for hea... Dans le forum How do I print this? (Printing help)	il y a 6 years
	This is the piece, printed with tape. It did better than oth... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Yes, I used many diferents adhesives. Glue stick helped a li... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Printing With NylonX Dans le forum How do I print this? (Printing help)	il y a 6 years
	Maybe try generating the Gcode again, it may solve the probl... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Thanks for your support. I will investigate and try to set t... Dans le forum Hardware, firmware and software help	il y a 6 years
	I did what you suggested, the filament is oozing very well, ... Dans le forum Hardware, firmware and software help	il y a 6 years
	I tried unscrewing a little , but the same thing happend. ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Filament coming out of the extruder Dans le forum Hardware, firmware and software help	il y a 6 years

Page 2 / 2 Précédent

Statistiques du forum

566 Forums

63.1 K Sujets

444.1 K Messages

23 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé