alejo.v2 – Aktivita – Prusa3D Forum

Notifications

Clear all

alejo.v2

Skupina: Registrovaný

Přidal se: 2018/06/21

Eminent Member

	I apply the glue when the bed is hot. And used 100°C for hea... In forum How do I print this? (Printing help)	před 6 years
	This is the piece, printed with tape. It did better than oth... In forum How do I print this? (Printing help)	před 6 years
	Yes, I used many diferents adhesives. Glue stick helped a li... In forum How do I print this? (Printing help)	před 6 years
	Printing With NylonX In forum How do I print this? (Printing help)	před 6 years
	Maybe try generating the Gcode again, it may solve the probl... In forum How do I print this? (Printing help)	před 6 years
	Thanks for your support. I will investigate and try to set t... In forum Hardware, firmware and software help	před 6 years
	I did what you suggested, the filament is oozing very well, ... In forum Hardware, firmware and software help	před 6 years
	I tried unscrewing a little , but the same thing happend. ... In forum Hardware, firmware and software help	před 6 years
	Filament coming out of the extruder In forum Hardware, firmware and software help	před 6 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed