Prusa3D Forum

Notifications

Clear all

airscapes

Groupe: Enregistré

A(ont) rejoint: 2021/01/19

Eminent Member

	Ok, with External perimeter first unchecked we have a usable... Dans le forum PrusaSlicer	il y a 3 months
	Gcode for a retraction and move this is without print extern... Dans le forum PrusaSlicer	il y a 3 months
	Did not really help..see attached.. Did notice that I have p... Dans le forum PrusaSlicer	il y a 3 months
	Interesting thought. That is the value used in S3d for non p... Dans le forum PrusaSlicer	il y a 3 months
	Ok thank! here is the project which I assume has all the se... Dans le forum PrusaSlicer	il y a 3 months
	What the SEAM is going on with this? Dans le forum PrusaSlicer	il y a 3 months
	I take it all back.. it does work. Set perimeter to 15mm/S ... Dans le forum PrusaSlicer	il y a 1 year
	Old Post new user .. one thing I really wanted to do was to ... Dans le forum PrusaSlicer	il y a 1 year
	DING DING DING DING!!! That is the problem! 🙂 I would assu... Dans le forum PrusaSlicer	il y a 5 years
	So where does it end the travel.. same as the image I showed... Dans le forum PrusaSlicer	il y a 5 years
	@joantabb I updated the stl to be .4 width.. this issue I am... Dans le forum PrusaSlicer	il y a 5 years
	@joantabb Any chance you can test this? Dans le forum PrusaSlicer	il y a 5 years
	@joantabb I have attached an STL of the same part with some... Dans le forum PrusaSlicer	il y a 5 years
	@neophyl Ture, it can be a problem if you had mixed models. ... Dans le forum PrusaSlicer	il y a 5 years
	Making the slicer obey Skirt .02mm from part is the simple f... Dans le forum PrusaSlicer	il y a 5 years
	Hi Joan! Thanks for looking at this but I think you will nee... Dans le forum PrusaSlicer	il y a 5 years
	Forgive me, this works as I describe in S3d and I use it all... Dans le forum PrusaSlicer	il y a 5 years
	I am totally confused.. what do you actually want? A brim is... Dans le forum PrusaSlicer	il y a 5 years
	I am just starting to use PS myself and had some issues with... Dans le forum PrusaSlicer	il y a 5 years
	@joantabb Retraction at 1mm on first print of the and second... Dans le forum PrusaSlicer	il y a 5 years

Page 1 / 2 Suivant

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

12 En-ligne

76 K Membres

Le dernier des messages: Prusa Core One - VIDEO BUILD GUIDE Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé