Prusa3D Forum

Notifications

Clear all

adriens

Groupe: Enregistré

A(ont) rejoint: 2020/05/27

Active Member

	Thank you @bobstro. I'll check but I think the position ofte... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Z-mesurements before prints are sometimes slowing down Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Here is another view of the Crystal clear, different angle: ... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Thanks 🙂 But I did all of this: cleaned with soap, hot wate... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@xayoz Thanks, I omitted to say that I performed first layer... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Here is a link to a video showing another failed attempt. Yo... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Another failed attempt with Azure blue: Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Printing issues with Prusament Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.8 K Messages

11 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé