Notifications
Clear all
adriens
Skupina: Registrovaný
Přidal se: 2020/05/27
Active Member
1
| Thank you @bobstro. I'll check but I think the position ofte... | před 5 years | |
| Z-mesurements before prints are sometimes slowing down | před 5 years | |
| Here is another view of the Crystal clear, different angle: ... | před 5 years | |
| Thanks 🙂 But I did all of this: cleaned with soap, hot wate... | před 5 years | |
| @xayoz Thanks, I omitted to say that I performed first layer... | před 5 years | |
| Here is a link to a video showing another failed attempt. Yo... | před 5 years | |
| Another failed attempt with Azure blue: | před 5 years | |
| Printing issues with Prusament | před 5 years |