Prusa3D Forum

Notifications

Clear all

adam.b5

Groupe: Enregistré

A(ont) rejoint: 2016/10/18

Active Member

	If you add text to an object, and the text is two lines, the... Dans le forum PrusaSlicer	il y a 2 years
	I'm a little late to this thread, butI have some info for pe... Dans le forum PrusaSlicer	il y a 2 years
	I should have mentioned, the "doors" being supported are ~14... Dans le forum General discussion, announcements and releases	il y a 5 years
	Here is the image Attachment removed Dans le forum General discussion, announcements and releases	il y a 5 years
	Outdoor linear bearing Dans le forum General discussion, announcements and releases	il y a 5 years
	Wierd issue with infill around circles Dans le forum Hardware, firmware and software help	il y a 7 years
	Help with support settings Dans le forum Software (Archive)	il y a 7 years
	Thanks Boris. I'm at 25 hours now so I will try your method... Dans le forum Print tips (Archive)	il y a 7 years
	Printing multiple parts...inefficient Dans le forum Print tips (Archive)	il y a 7 years
	Wierd issue when using Color Print. Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Thanks. It was set at 80% on the LCD. I was not sure what ... Dans le forum Others (Archive)	il y a 8 years
	Just built. Easy question. Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

21 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé