|
Thanks for the follow-up! Its concerning that the replacemen... Dans le forum Hardware, firmware and software help |
il y a 3 days |
|
It should get uniform again after being heated for some time... Dans le forum General discussion, announcements and releases |
il y a 6 days |
|
Does it happen on different prints? Also, try a pre-sliced p... Dans le forum Assembly and first prints troubleshooting |
il y a 2 weeks |
|
6.5.3 fixed a bug where input shaping was being applied to t... Dans le forum Hardware, firmware and software help |
il y a 2 weeks |
|
IIRC, that final purge is made automatically after the print... Dans le forum Assembly and first prints troubleshooting |
il y a 2 weeks |
|
I don't think layer shifts this severe are caused just by ga... Dans le forum Assembly and first prints troubleshooting |
il y a 3 weeks |
|
I've changed the end gcode on Prusa Slicer so that it moves ... Dans le forum Assembly and first prints troubleshooting |
il y a 3 weeks |
|
Share some photos of the belts, the gantry, motors, etc. Rec... Dans le forum Assembly and first prints troubleshooting |
il y a 3 weeks |
|
The noises don't align with the X axis movements, they do al... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
That is very interesting! I do wonder if what could be causi... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
Do you think the "waves" on the measured vibration match the... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
Thanks for testing it further! Was the accelerometer test ma... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
Another possibility is using longer screws on the holder, wi... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
Interesting path! This would also tie well with the fact tha... Dans le forum Hardware, firmware and software help |
il y a 1 month |
|
Does that print uses gyroid infill? Looks a bit like it. Try... Dans le forum Hardware, firmware and software help |
il y a 2 months |
|
The temperature was at 215, right? Are you sure the filament... Dans le forum Assembly and first prints troubleshooting |
il y a 2 months |
|
Comparing the two bearings in the pulley, one is really bad.... Dans le forum Hardware, firmware and software help |
il y a 2 months |
|
And here is a video. The best way I've found to be able to a... Dans le forum Hardware, firmware and software help |
il y a 2 months |
|
Mine started making more noise. It is coming from the front ... Dans le forum Hardware, firmware and software help |
il y a 2 months |
|
Yep, someone replaced the bearings with Vesconite:/p> Dans le forum Hardware, firmware and software help |
il y a 2 months |
