|
Thanks for the follow-up! Its concerning that the replacemen... Im Forum Hardware, firmware and software help |
Vor 3 days |
|
It should get uniform again after being heated for some time... Im Forum General discussion, announcements and releases |
Vor 6 days |
|
Does it happen on different prints? Also, try a pre-sliced p... Im Forum Assembly and first prints troubleshooting |
Vor 2 weeks |
|
6.5.3 fixed a bug where input shaping was being applied to t... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
IIRC, that final purge is made automatically after the print... Im Forum Assembly and first prints troubleshooting |
Vor 2 weeks |
|
I don't think layer shifts this severe are caused just by ga... Im Forum Assembly and first prints troubleshooting |
Vor 3 weeks |
|
I've changed the end gcode on Prusa Slicer so that it moves ... Im Forum Assembly and first prints troubleshooting |
Vor 3 weeks |
|
Share some photos of the belts, the gantry, motors, etc. Rec... Im Forum Assembly and first prints troubleshooting |
Vor 3 weeks |
|
The noises don't align with the X axis movements, they do al... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
That is very interesting! I do wonder if what could be causi... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
Do you think the "waves" on the measured vibration match the... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
Thanks for testing it further! Was the accelerometer test ma... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
Another possibility is using longer screws on the holder, wi... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
Interesting path! This would also tie well with the fact tha... Im Forum Hardware, firmware and software help |
Vor 1 month |
|
Does that print uses gyroid infill? Looks a bit like it. Try... Im Forum Hardware, firmware and software help |
Vor 2 months |
|
The temperature was at 215, right? Are you sure the filament... Im Forum Assembly and first prints troubleshooting |
Vor 2 months |
|
Comparing the two bearings in the pulley, one is really bad.... Im Forum Hardware, firmware and software help |
Vor 2 months |
|
And here is a video. The best way I've found to be able to a... Im Forum Hardware, firmware and software help |
Vor 2 months |
|
Mine started making more noise. It is coming from the front ... Im Forum Hardware, firmware and software help |
Vor 2 months |
|
Yep, someone replaced the bearings with Vesconite:/p> Im Forum Hardware, firmware and software help |
Vor 2 months |
