PrintShift - auto-eject prints modification for prusa mini
 
Notifications
Clear all

PrintShift - auto-eject prints modification for prusa mini  

  RSS
Antonín Janků
(@antonin-janku)
Active Member
PrintShift - auto-eject prints modification for prusa mini

Good day everyone,

I´ve recently discovered this project, which aims to automatise printing on prusa mini. It ejects prints and thus allows you to print continuosly (almost indefinetly).

https://printshift3d.com/

Has anybody any experience with it? Are there any similar maybe more successfull variations?
What is your opionion on this matter?

I am considering this as a way to be ale to print larger/longer models, and even maybe try to start a mini mini farm(pun intended).

 

Have a great day, let me know what you think!

Cheeers

 

Anthony

 

Posted : 23/04/2022 7:46 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member
RE: PrintShift - auto-eject prints modification for prusa mini

As often as this happens one might start to think the forums where being seeded.

The Filament Whisperer

Posted : 24/04/2022 3:50 am
fuchsr liked
fuchsr
(@fuchsr)
Famed Member
RE:

@OP: Sure. If you think this works I have a bridge in New York City to sell you.

Posted : 24/04/2022 11:55 am
MysDawg liked
Antonín Janků
(@antonin-janku)
Active Member
Topic starter answered:
RE: PrintShift - auto-eject prints modification for prusa mini

Bridge? I might be interested

Posted : 24/04/2022 2:39 pm
Antonín Janků
(@antonin-janku)
Active Member
Topic starter answered:
RE: PrintShift - auto-eject prints modification for prusa mini

Sorry, but I didnt catch your drift? was this being discussed here before, because I didnt find any mention about this topic.

Posted : 24/04/2022 2:40 pm
John Doe
(@john-doe-3)
Estimable Member
RE:

I like the idea (seen only the youtube), maybe I will also implement it later on.

But a question, there are also screws in the middle of the bed, which would block the movement to side. Removing from the center would cause ber anomalies

This post was modified 4 months ago by John Doe
Posted : 25/04/2022 6:33 am
Antonín Janků
(@antonin-janku)
Active Member
Topic starter answered:
RE: PrintShift - auto-eject prints modification for prusa mini

There is quite detailed guide on theirs youtube channel and if I am not mistaken the middle screws from bed were removed

Posted : 25/04/2022 9:08 am
Share: