Pi0W gpio to update firmware?
Hi,
I am curious if it is possible for the pi0w to update the einsy rambo's firmware via the gpio?
I am not seeking a short answer such as
- "no it won't work because octoprint/gina/foosel said so"
- "pi0w wasn't recommended by foosel"
- "pi0w don't have capacity"
- "pi0w not powerful enough"
As far as I know the board resets several time during the falshing, but what happened to the gpio line, does pi0w's power been cut off as well during the process? or the serial connection terminated by itself?
Since pi0w don't have that performance as pi3b+ does, we just have to wait until it is complete eventually correct?
Best Answer by Asraff Amzani:
I'm sorry, wrong topic, supposed to be in mk3/s section
RE: Pi0W gpio to update firmware?
I'm sorry, wrong topic, supposed to be in mk3/s section
RE: Pi0W gpio to update firmware?
Hi,
I am curious if it is possible for the pi0w to update the einsy rambo's firmware via the gpio?
I am not seeking a short answer such as
- "no it won't work because octoprint/gina/foosel said so"
- "pi0w wasn't recommended by foosel"
- "pi0w don't have capacity"
- "pi0w not powerful enough"
As far as I know the board resets several time during the falshing, but what happened to the gpio line, does pi0w's power been cut off as well during the process? or the serial connection terminated by itself?
Since pi0w don't have that performance as pi3b+ does, we just have to wait until it is complete eventually correct?
I have never used the Pi zero W. On the Prusa Mini I have also installed the 3B+ and everything runs, like on the MK3, without errors or malfunctions. MK3 is connected over GPIO, Mini over USB.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.