Notifiche
Cancella tutti

For those that use octopi and picam  

  RSS
addohm
(@addohm)
Estimable Member
For those that use octopi and picam

https://www.printables.com/model/443138-mk4-x-idle-picam-mount-for-octoprint

Postato : 05/04/2023 2:31 am
bazmarc hanno apprezzato
Doriann
(@doriann)
Eminent Member
RE: For those that use octopi and picam

Nice Design! Is octopi working with the MK4? I think I saw in a FB group its not working correctly 

Postato : 05/04/2023 3:40 am
addohm
(@addohm)
Estimable Member
Topic starter answered:
RE:

I got it working last night and have done some further testing this morning.  Anything that alters gcode has been disabled.  Other than gcode altering plugins, it's working.

Posted by: @doriann

Nice Design! Is octopi working with the MK4? I think I saw in a FB group its not working correctly 

Tell your FB group to turn off the wifi by switching the network to Eth, then they'll be able to connect serially over the USB port.

Postato : 05/04/2023 1:55 pm
Doriann hanno apprezzato
inetjnky
(@inetjnky)
Utenti
RE: For those that use octopi and picam

how much ram is recommended on the pi to use octopi?  Looking to buy a new pi to setup octopi at some point.

Postato : 22/04/2023 4:49 am
addohm
(@addohm)
Estimable Member
Topic starter answered:
RE: For those that use octopi and picam

Future versions of OctoPrint will need a minimum of a Pi3 - so that makes it 512MB RAM.

Postato : 24/04/2023 1:48 pm
Richard Kramer
(@richard-kramer)
Active Member
RE: For those that use octopi and picam

I have tried all of that with only the USB C from my pi & it keeps timing out & turning the heat settings off

Posted by: @addohm

I got it working last night and have done some further testing this morning.  Anything that alters gcode has been disabled.  Other than gcode altering plugins, it's working.

Posted by: @doriann

Nice Design! Is octopi working with the MK4? I think I saw in a FB group its not working correctly 

Tell your FB group to turn off the wifi by switching the network to Eth, then they'll be able to connect serially over the USB port.

 

Postato : 25/06/2023 10:54 am
Condividi: