Z Hop needed after filament change
 
Notifications
Clear all

[Résolu] Z Hop needed after filament change  

  RSS
CWCDesigns
(@cwcdesigns)
Active Member
Z Hop needed after filament change

Is there a way to add in a Z Hop that starts immediately after a filament change so the hot end doesn't drag across the print on it's way to to resuming the print and there by killing the nice and clean surface? So after you change the filament and it's ready to go and drops down to the layer that it will be printing at it does the hop from the corner back to where it's going to start printing. As you can see in my pic it left a nice streak of black embedded in the white.

Publié : 19/08/2023 7:23 pm
Vous a aimé
Partager :