Notifiche
Cancella tutti
What is this?
Hi,
New here and new to Prusa Slicer. I have a qustion about a print I'm printing witch have a small "defekt" and I can't seem to figure out why??
The vertical lines see here are in the print as well. How do I get rid of them?
https://imgur.com/Q0LsKAZ
Thanks
Gert
Best Answer by KJERFORM:
Found the answer here:
https://forum.prusa3d.com/forum/prusaslicer/prusa-slicer-2-0-how-would-i-go-about-to-get-rid-of-that-vertical-seam/
Postato : 02/11/2019 7:11 pm
RE: What is this?
I assume you are talking about the seams (start and endpoints of a layer). You can't get rid of them. You can only change there placement.
Postato : 03/11/2019 10:48 am
Topic starter
answered:
RE: What is this?
Found the answer here:
https://forum.prusa3d.com/forum/prusaslicer/prusa-slicer-2-0-how-would-i-go-about-to-get-rid-of-that-vertical-seam/
Postato : 03/11/2019 1:24 pm